Replacing A Bathroom Vanity
Set and fasten the vanity.
Replacing a bathroom vanity. How to replace a bathroom vanity 1. How to replace a bathroom vanity step 1. Disconnect the sink trap from the sink s tailpiece vertical drainpipe by hand.
Check the vanity is level then use your hammer drill to put two screw holes through the back rail of the cabinet and into the wall. Place the plastic gasket on the faucet. Shut the hot and cold water shut off valves underneath the sink.
With little guidance and planning you will be able to go through the replacement like a piece of cake. Lowes experts show us how to replace a vanity and sink. Loosen the caulk between the vanity and the wall with a utility knife.
Use a bucket to catch any water that drips from the supply. Then while holding the faucet from underneath screw on fastening nuts. Measure the dimensions of the existing vanity top using a tape measure.
Depending on the size of the existing vanity it should be possible to have a similar new vanity or a custom unit made to replace the original but a chat with a plumber should be arranged to recommend suitable options and plan a schedule to remove the old and install the new including any necessary waterproofing or tile repairs btw careful removal could allow the original sink taps and even the counter to be saved and recycled into a new vanity that matches the bathroom perfectly with the. Turn off the water and disconnect the supply lines. Insert the faucet into the designated holes on the vanity top.
How to remove and replace a bathroom vanity top step 1. Instructions locate the wall studs. Replacing a bathroom vanity cabinet is a fairly easy task.
Inspect the side gap sidewall installation. On the sides go all the way down to the. Use an electronic stud finder to locate at least one wall stud on the wall behind the vanity.
Assemble the bathroom faucet and drain on the sink before you attach it to the vanity. Measure the height of the vanity cabinet not including the countertop and transfer this. Measure for the new vanity top.
Install the bathroom vanity. Use an adjustable wrench to disconnect the hot and cold water supply lines from the shut off valves. You must buy the correct size of the vanity for your bathroom.
