Installing Bathroom Faucet And Drain
The drain line for the toilet should be either a 3 inch 7 62 cm or 4 inch 10 16 cm line.
Installing bathroom faucet and drain. There will be two nuts most likely plastic that can be tightened on the underside of the faucet to hold it down with a crescent wrench. Wet dry shop vac pliers plumber putty bucket pop up drain assembly at this point you re now ready to install your pop up drain. For your bathroom you will need multiple sizes of drain lines.
Start by removing any extra water. Then install the faucet handle with the groove facing toward the front of the sink. Screw it into.
Install the spring and screw the gray piece back into the faucet with the indicator facing toward the back of the sink. The fewer moving. Slide the bottom gasket washer and nut on the top of the drain body and tighten the mounting nut until it is snug.
Installing your pop up. A basin wrench is a standard plumbing tool that is indispensable for removing and installing most faucets. Apply a thin layer of.
The first part of the faucet that needs to be installed is the plastic piece that goes between the sink and the faucet itself. Apply clear silicone to the underside of the drain collar. Clean the sink with a household cleaner and dry thoroughly.
No washers are required here. You simply slip a nut onto the waste drain and press it against the other pipe then hand tighten the nut. This bathroom really gets a lot of use and my thinking was simple.
Prepare the new pop up drain stopper. And it looks pretty cool when you re finished. This is going to be one of the easiest faucets to install.
After that simply set the faucet in. The fixture i chose had only one control as opposed to two handles. Disassemble the pieces of the new pop up assembly and unscrew and remove the.
Connect the drain lines. From beneath the sink tighten the mounting nuts to keep the faucet in place. How to install a bathroom faucet drain stopper 1.
Wipe away any excess putty from around the faucet base. Next find the washer that will fit onto the drain under the sink. Use a basin wrench or a sink installer tool being careful to not over tighten the nuts.
This was intentional so as to hopefully minimize the chance for further adventures in bathroom faucet repair. After you attach the pipe to the toilet drain the pipe should slope downwards toward the main drain line. Apply pipe joint compound.
Place a slip joint nut on the pipe first followed by the washer. Loosen and remove the p trap from the branch drain and sink drain tailpiece using. It s time to start reassembling now.
Instructions remove the old drain assembly. The wrench allows you to reach into the cramped area behind the sink to loosen or tighten the nuts that hold the faucet to the sink and the nuts that connect the supply lines. You ll note one of them is much too loose but the other one fits just right.
